CLLQL - BLUE QUICK DRY ENAMEL #15200
- MSDS: CLLQL
- Manufacturer: FARWEST PAINT MANUFACTURING CO
- Product Name: BLUE QUICK DRY ENAMEL #15200
- National Stock Number: 8010-01-433-8382
Product Identification
Product ID:BLUE QUICK DRY ENAMEL #15200
MSDS Date:06/22/1993
FSC:8010
NIIN:01-433-8382
Status Code:A
MSDS Number: CLLQL
Responsible Party
TUKWILA, WA 98168
US
Emergency Phone: 206-244-8844
Info Phone: 206-244-8844
Preparer: HENRY SIMMONS
Cage: 6F266
Contractor
Telephone: 206-244-8844
Cage: 6F266
Ingredients
ALIPHATIC HYDROCARBON
CAS: 8052-41-3
RTECS: WJ8925000
OSHA PEL 2900 MG/M3;500 PPM
ACGIH TLV: 525 MG/M3;100 PPM
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Effects of Overexposure:THIS MATERIAL MAY CAUSE IRRITATION,
SENSITIZATION, OR DEFATTING OF SKIN UPON PROLONGED OR REPEATED
CONTACT. INHALATION: EXCESSIVE EXPOSURE TO VAPORS OR SPRAY MISTS
CAN RESULT IN HEADACHES, DIZZINESS, NAUSEA AND LOSS OF
CONSCIOUSNESS. SOME HAVE ASSOCIATED REPEATED AND PROLONGED
OCCUPATIONAL OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN AND
NERVOUS SYSTEM DEPRESSION. THIS MATERIAL MAY BE AN EYE IRRI TANT.
Medical Cond Aggravated by Exposure:NONE; WHEN USED IN ACCORDANCE WITH
SAFE HANDLING INSTRUCTIONS. (SEE SECTION VIII)
First Aid
First Aid:SKIN: PROMPTLY WAS WITH SOAP AND WATER, REMOVE AND WASH ANY
CONTAINIMATED CLOTHING BEFORE REUSE EYES: FLUSH WITH LARGE
QUANTITIES OF WATER FOR 15 MINUTES AND SEEK MEDICAL ATTENTION
SWALLOWING: IF IN JESTED DO NOT INDUCE VOMITING: KEEP PERSON WARM
AND QUIET AND GET MEDICAL ATTENTION. ASPIRATION OF MATERIAL INTO
LUNGS CAN CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL.
INHALATION: REMOVE VICTIM TO FRESH AIR IMMEDIATELY. IF RESPIRATORY
SYMPTONS DEVELOP, SEEK MEDICAL ATTENTION AT ONCE.
Fire Fighting
Flash Point:=41.7C, 107.F
Lower Limits:.7%
Extinguishing Media:FOAM, CO2, DRY CHEMICAL AND WATER FOG. USE THE
ABOVE OR ANY CLASS B EXTINGUISHING AGENT. WATER MAY BE UNSUITABLE
AS AN EXTINGUISHING MEDIUM.
Fire Fighting Procedures:FIREFIGHTERS AND OTHER EXPOSED TO VAPORS OR
PRODUCTS OF COMBUSTION SHOULD WEAR SELF-CONTAINED BREATHING
APPARATUS. EVACUATE AREA OF UNPROTECTED PERSONNEL. WEAR PROTECTIVE
CLOTHING.
Unusual Fire/Explosion Hazard:VAPORS MAY FORM AN EXPLOSIVE MIXTURE IN
AIR MAY BE IGNITED BY SPARKS, PILOT LIGHT, ETC. CLOSED CONTAINERS
MAY RUPTURE WHEN EXPOSED TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:REMOVE ALL SOURES OF IGNITION VENTILATE AREA.
ABSORB SPILL WITH AN ABSORBENT MATERIAL SUCH AS SAWDUST,
VERMICULITE OR SAND AND PLACE MATERIAL INTO A CLOSED CONTAINER. IF
LARGE SPILL, DIKE AREA TO PREV ENT THIS MATERIAL FROM ENTERING
WATER SYSTEMS OR SEWERS. WEAR PROTECTIVE EQUIPMENT DURING CLEANUP.
Handling
Handling and Storage Precautions:AVOID PROLONG OR REPEATED INHALATION
OF HEATED VAPORS OR SPRAY MIST. KEEP AWAY FROM HEAT OR OPEN FLAME.
THIS MATERIAL MAY CAUSE SENSITZATION. DO NOT GET INTO EYES, ON SKIN
OR CLOTHING. DO NOT ALLOW CO NTANIMATED CLOTHING TO CONTACT SKIN.
DO NOT WELD ON FULL OR EMPTY CONTAINERS. KEEP CONTAINERS CLOSED
Exposure Controls
Respiratory Protection:A CANISTER-TYPE RESPIRATOR MUST BE WOTN TO
PREVENT THE INHALATION OF VAPORS MISTS WHEN THE TLV OR PEL IS
EXCEEDED.
Ventilation:GENERAL VENTILATION IS REQUIRED DURING NORMAL USE. LOCAL
VENTILATION MAY BE REQUIRED DURING CERTAIN OPERATIONS TO KEEP
EXPOSURES LEVEL BELOW THE LIMITS.
Protective Gloves:CHEMICAL RESISTANT, NITRILLE, NEOPRENE OR RUBBER
GLOVES REQUIRED.
Eye Protection:WEAR FACE SHIELD OR CHEMICAL GOGGLES.
Other Protective Equipment:WEAR PROTECTIVE CLOTHING TO PREVENT SKIN
CONTACT. EYE WASH STATION AND SAFETY SHOWER SHOULD BE AVAILABLE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING.
Supplemental Safety and Health
Chemical Properties
Boiling Pt:=152.8C, 307.F
B.P. Text:307-390F
Vapor Pres:2.6MM HG @ 20C
Vapor Density:> AIR
VOC Pounds/Gallon:470
VOC Grams/Liter:7.7
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:BLUE OILY LIQUID, MILD ODOR
Percent Volatiles by Volume:65%
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDANTS. ACIDS, BASES AND EPOXY HARDNERS
UNDER UNCONTROLLED CONDITIONS.
Stability Condition to Avoid:HEAT, SPARKS & OPEN FLAME. IF PRODUCT
CONTAINS ALUMINUM. MOISTURE IN CLOSED COINTAINERS WILL GENERATE
HYDROGEN GAS.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION CAN YIELD CARBON
MONOXIDE AND TOXIC VAPORS
Disposal
Waste Disposal Methods:IF DISCARDED, THIS MATERIAL AND CONTAINERS
SHOULD BE TREATED AS HAZARDOUS WASTE BASED ON THE CHARACTERISTICS
OF IGNITABILTY AS DEFINED UNDER FEDERAL RCRA REGULATIONS (40 CFR
261). DISPOSAL OF THIS MAT ERIAL OR ITS CONTAINERS REQUIRES
COMPLIANCE WITH APPLICABLE, PACKGED AND RECORDKEEPING STANDARDS.
Toxicology
Toxicological Information:NA
Other Information
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
Ecology
Ecological:AVOID DISCHARGE TO NATURAL WATERS.
Regulatory
SARA Title III Information:PURSUANT TO TITTLE THREE OF THE SUPERFUND
AMMENDMENT AND REAUTHORIZATION ACT OF 1986 (SARA) AND 40 CFR PART
372, THIS PRODUCT CONTAINS, OR MAY CONTAIN A TOXIC CHEMICAL IN THE
QUANTITY SUBJECT TO THE R EPORTING REQUIREMENTS UNDER SECTION 313.
Federal Regulatory Information:US POSTAL REGULATIONS: NON-HAZARDOUS,
NON-FLAMMABLE, OKAY TO SHIP BY MAIL.